Toshiba TEC EM1-33046A - Manual (Page 27)

11. SELF TEST EM1-33046A
11. SELF TEST
11. SELF TEST
To initiate the Self Test Mode, depress the Feed key while turning on the printer.
The printer will first calibrate the label length. If a label edge is not detected within 7", the printer will then
stop attempting to feed labels and treat the media as continuous thermal paper.
Firstly, the printer will print a pattern to check the performance of the print head.
Following the calibration of label length, the printer will print internal settings, including:
1. Print head checking pattern.
2. Printer type and firmware version
3. Head Run Distance
4. Serial port setting
5. Code page
6. Country code
7. Print Speed setting
8. Print Density setting
9. Label Size setting
10. Gap (Bline) Width and Offset Setting
11. Backing Paper Transparence
12. File list
13. Memory available
After the self test is complete, reset the printer for use by turning the Power switch off and on.
<Sample Test Label>
11-1