TOA Electronics AM-821 - Manual (Page 4)

PART DESCRIPTION
POWER SWITCH
Place this switch in the ON position and power is
supplied.
Note : When not loading the tape :
The auto switch is placed in the manual
mode.
When loading the tape :
Unrecorded tape the auto switch is
placed in the manual mode.
Recorded tape
the auto switch is
placed in the automatic mode.
AUTO SWITCH
When using a built-in interval timer or an external
timer , set this switch to ON (automatic mode).
Place this switch in the OFF position (manual mode)
for the tape deck operation
MESSAGE OMIT SELECTOR
These selectors function only when placing the auto
switch
in the automatic mode. If wishing to omit
one or more of the recorded messages (No.1 through
No.9), depress this switch(es).
TAPE COUNTER, RESET BUTTON
This indicates how far the tape has travelled. Depress
the reset button to reset the tape counter display to
"000".
CASSETTE RECEPTACLE
Load the cassette tape with the exposed tape face
down, and then close lid.
Note
: Be sure to depress the eject button after the
auto switch is turned to the manual mode.
Ejecting the tape in the automatic mode may
lead to malfunction of the deck.
EJECT BUTTON
Depress this button to open lid of the cassette
receptacle. (Do not depress this button while the
cassette tape is travelling.)
MESSAGE COUNTER
This indicates the message number while its
announcement is being made. The message number
to follow next is indicated when the tape motion stops.
TAPE DECK CONTROLS and LED INDICATIONS
These controls function only when placing the auto
switch
in the manual mode.
Rewinds the tape at high speed.
Advances the tape at high speed.
Advances the tape for playback, and the
green LED illluminates during playback.
The tape stops travelling automatically
after each announcement has been
finished.
Depress this button to stop the tape motion
or to release the recording mode.
First of all, depress this button before starting
recording. Thereafter, also depress after
recording of each message is finished. The tape
continues to travel for approximately 7 seconds to
make an unrecorded sound section on the tape
even after the recording is finished and this
button is depressed. The red LED of this button
flashes during tape travel and it illuminates
instead of flashing when the tape motion stops.
After placing in the recording standby mode by
depressing the REC SPACE button, depress this
switch and record with the remote microphone
RM-820.
TIMER SWITCH
This functions only when placing the auto switch in
the automatic mode. Place this switch in the OFF
position when an external timer is used.
PHONES (HEADPHONE) JACK
Accomodates stereo or monaural headphone.
Insertion of the headphone into this jack cuts line
output out.
Note
: When inserting the headphone into this jack,
output signal from the line out is not fed.
— 4 —