TOA Electronics AM-821 - Manual (Page 7)

COMPLETED TAPE AFTER RECORDING PROCEDURE
RECORDIN G
OPERATIO N
BUTTO N REC
SPACE
REC
RUN REC
SPACE
REC
RUN REC
SPACE
REC
RUN REC
SPACE
REC
RUN REC
SPACE
REC
SPACE
REC
SPACE
STOP
TAPE
HEA D
MESSAGE #1 MESSAGE #2 LAST MESSAGE
UNRECORDED
SOUND SECTION
AUTOMATIC
PLAYBACK
PLA Y BACK
AUT O
STOP
PLA Y BACK
AUT O
STOP AUT O
STOP
PLA Y BACK
AUT O
STOP
AUT O
STOP ACTIVATIO N BY TIMER AUTO
STOP
AUTOMATIC REWINDING
CONFIRMATION OF RECORDING
To ensure that the recorded message can be annnounced properly, confirm if
(A) the number appearing on message counter display is in agreement with the indexing number for the
announced message. Be sure to always start operation from the beginning of the tape after initial
automatic tape rewinding as the number indicated on message counter display does not always
correspond to the announced message after Fast Forward or Rewind facility has been used.
(B) the tape motion does not stop during announcement due to a long break made during recording.
(C) the recorded level is adequate enough to override the background music.
(D) the tape is provided with the unrecorded sound section that is sufficient for automatic tape rewinding
after all messages have been announced.
1. Switch the power on.
2. Place the auto switch in the manual mode, load the recorded tape and rewind it. (The "1" is indicated
on message counter display.)
3. Depress the PLAY button. The tape begins travelling to play message No.1. In this event, confirm that
the announcement overrides the background music. The tape motion stops automatically after the
announcement of message No.1 is finished and "2" appears on message counter display, restoring the
background music.
4. Repeat the procedure of step 3 and check the recording situation as well as Items (A) through (C).
5. After all announcements have been finished, again depress the PLAY button to confirm that the
unrecorded sound section continues to travel for longer than 20 seconds.
— 7 —