Tripp Lite SREXTENDER - Manual (Page 2)

2
F
G
A B C D E H N
O
P
K
L
M
I
J
A
B
C
D
48/42U
1-1
Preparation
(continued)
Note: The hinge swivels H and 12 hinge swivel screws L are pre-installed in the vertical sections A through D .
Parts List
(If any parts are missing, contact Tripp Lite.)
A Lower Left Vertical Section (1)
B Lower Right Vertical Section (1)
C Upper Left Vertical Section (1)
D
Upper Right Vertical Section (1)
E Top Section (1)
F Bottom Section (1)
G 1U Blanking Panels (3)
H Hinge Swivels (6 - all pre-installed)
I Hinges (4)
J
Cable Manager Brackets (2)
K M6 x 12 mm Flat-Head Screws (8)
L M6 x 12 mm Pan-Head Screws
and Washers (14 total - 12 pre-installed)
M M5 x 10 mm Pan-Head Screws
and Washers (40)
N Grounding Cable (1)
O
M5 x 20 mm Pan-Head Screws and
Washers (4)
P M4 x 8 mm Pan-Head Screws
and Washers (8)
1 – Frame Assembly
Note: For 25U enclosures, you will use only the lower vertical sections A and B . You will not use the upper vertical sections C and D .
For 48U and 42U enclosures, you will use all four vertical sections.
(For 25U enclosures, skip this step.) Slide the lower left vertical
section
A inside the upper left vertical section C as shown.
Repeat for the lower right vertical section B and the upper right
vertical section D . The vertical sections are not interchangeable,
so refer to the diagram to confirm that you’re assembling the
correct sections.
1-1