Uniden UH089 - Manual (Page 10)

To deactivate SCAN, press the button
or the PTT button
UNIDEN Model UH-089 FRS CB Radio
Operation
9
If the Priority Channel becomes active the radio will stay on that channel for as long as the signal is present. If
the received signal ceases, Priority Scanning continues after 3 seconds.
If scanning stops on a channel which is not a Priority Channel, UH-089 will continue monitoring the Priority Channel
for activity while listening to the active one.
Group Scan (GS) Mode
Allows you to monitor a Priority (Instant) Channel while scanning (Instant Priority channel see p. 11)
To use GS Mode Scanning, press . GS icon appears on the
display.
GS Scanning checks the Instant Priority Channel for activity regularly.
FM
INST
GS
VOX
CTCSS
S/RF VOL S/RF VOL
Programming Scan Channels
Select which Scanning Mode you wish to use
- OS or GS.
Select the channel you want to store.
Press to store. MEM icon appears
and a short tone beep is heard.
To remove the channel from Memory, press
once more. The MEM icon disappears.
MEM
MEM
SLCT
STORE CTCSS
SCAN OS/GS MEM INST
INST SET
DUP
FM
MEM GS SCAN
S/RF VOL
Rotary
Channel
Selector
OS/GS
NOTE
OS is indicated by the absence of
the GS icon.
SCAN
SCAN MEM
SLCT
STORE CTCSS
SCAN OS/GS MEM INST
INST SET
DUP
FM
GS SCAN
S/RF VOL
Rotary
Channel
Selector
MEM
NOTE
If SCAN is deactivated while it is tuned to an active channel, the UH-089 will stay on that activechannel.
If none of the channels are active, the UH-089 will reinstate the Priority Channel.
If GS Scanning is initiated when there are no channels programmed in GS memory, an error tone
will be heard and scanning will not start (see Programming Scan Channels - below).
NOTE