U-Line 2275DWRWS - Manual (Page 15)

2275DWRWS, 2275DWRWOL 15
Adjust Drawers
Checking Drawer Alignment
The unit’s drawers are aligned at the factory before
shipment. However, their alignment could have been
disturbed during shipment.
Figure 15
See Figure 15. Check each drawer to confirm that it is
aligned:
• Side-to-Side — When viewed from the top, the
drawer front should be square with the sides of the
cabinet.
• Front-to-Back — When viewed from the side, the
drawer front should be straight with the cabinet’s
sides, not cocked forward or back.
• Top-to-Bottom — When viewed from the front, the
drawer should be level horizontally.
If either drawer is not aligned, carefully follow
instructions to remove that drawer, make the necessary
adjustment and re-install the drawer.
Adjusting Drawer Alignment
WARNING
SHOCK HAZARD — The unit must be unplugged
from the wall outlet during drawer removal,
adjustment and re-installation.
Drawer Removal
Figure 16
1. Confirm that the unit is unplugged from wall outlet.
2. Unplug the drawer’s connection wiring (top drawer
only).
3. Remove the mounting screws. See Figure 16.
4. Pull the drawer completely out of the unit.
CAUTION
Use care when handling the drawer. Drawer edges,
drawer rail and the unit’s slide may be sharp.
IMPORTANT IMPORTANT
Drawer adjustments are made by moving the slide
that carries the drawer’s rail. Minor adjustments
may be made by loosening one of the slide’s
mounting screws, adjusting the slide and
retightening the screw. Severe adjustments may be
made by removing the slides’ mounting screws,
drilling new mounting holes and remounting the
slide.
Aligned
Side-to-Side
Aligned
Front-to-Back
Aligned
Top-to-Bottom
ULIN_0001a_A Mounting
Screw
ULIN_0001b_A
ULIN_016357_30179.fm Page 15 Thursday, February 1, 2007 1:24 PM