Ulead KDC330 - Manual (Page 28)

55
8.Details of Each Function
Sidelight Method
● In KDC330, conversion to sidelight mode in Still Automatic Capture
mode, Still Manual Capture mode and Still Continuous Capture mode is
possible.
● Multi sidelights
Determines the optimum exposure value by dividing the capture scope
of CCD and side lighting. You may get precise capture in a variety of
scenes. In a usual picture capturing, we recommend multi sidelights
capturing.
● Center sidelight
By giving 80% to ®˘ scope of the center of the screen and side lighting,
the exposure value is determined. This mode is suitable when capturing
pictures based on the center exposure value, according to the intention
of the person taking pictures.
● Spot sidelight
By side lighting only 1/32 scope of the entire central part of the screen,
the exposure value is determined. The sidelight scope is indicated in the
center of the LCD monitor. This mode is suitable, when you want to
capture pictures based on partial exposure of the screen: e.g. - When
there is reverse light or severe difference in contrast.
EV Setting
● EV refers to exposure value, in other words, exposure calibration value.
● Exposure calibration can brighten or darken the screen according to
capture conditions and purposes.
54
● In KDC330, the conversion is possible in Still Automatic Capture mode,
Still Manual Capture mode and Still Continuous Capture mode.
◎ The following are available exposure calibration devices:
Use Up and Down of the Direction key for conversion.
13-step conversion is possible with 1/3 step.
◎ When you cancel exposure calibration, set it to 0/3.
ISO Setting
● ISO refers to film sensitivity, which is the international standard.
ISO refers to sensitivity toward light. In a digital camera, which does not
have film, conversion value is used.
● The standard sensitivity is 100. However, in a low brightness, sensitivity
becomes higher. A photographer may set higher than standard, or take
pictures brightly in a dark place.
● Conversion in Still Manual Capture mode is possible in KDC330.
Auto: Standard sensitivity is set in a usual photographing; however, in a
low brightness, the sensitivity increases.
100: Standard sensitivity (Equivalent to ISO 100)
200: ISO 200
400: ISO 400
● If sensitivity is higher, take pictures in a place where the amount of light
is not sufficient.