Uniden BT-1018 - Manual (Page 3)

3
Registering to a Base
The accessory handset won't work until you register it to a base!
Compatible Bases
This handset is designed for use with Uniden's DECT4096, DECT4086 and DECT4066
bases. Other Uniden DECT6.0 bases might be compatible with this handset. For the
most up-to-date list of which bases this handset is compatible with, see our website.
Registration Methods
There are two different registration methods, but it's easy to figure out which one
applies to your handset and base. Answer the question to register the handset to
one of the compatible bases.
Does the handset fit in the base cradle?
Yes Place the handset in the base. The display should say Handset Registering.
No 1. On the base, open the menu and select Register Handset.
2. On the handset, press and hold PoUnD (#) until the handset display says
Handset Registering (about 2 seconds).
After about 30 seconds, the handset display should say Registration Complete.
Test the connection
Pick up the handset and press TAlk . Make sure you get a dial tone.
(Press EnD to hang up.)
If... Try...
- you don't hear a dial tone
- the display says Registration Failed
Making sure the handset is fully
charged, then trying again.