Asus P6-P7H55E - Manual (Page 61)

4-24 Chapter 4: BIOS setup
4.6.3 Boot Settings Configuration
Select Screen
Select Item
+- Change Option
F1 General Help
F10 Save and Exit
ESC Exit
Boot Settings Configuration
Quick Boot [Enabled]
Full Screen Logo [Enabled
AddOn ROM Display Mode [Force BIOS]
Bootup Num-Lock [On]
Wait For ‘F1’ If Error [Enabled]
Hit ‘DEL’ Message Display [Enabled]
Allows BIOS to skip
certain tests while
booting. This will
decrease the time
needed to boot the
system.
Set this item to [Enabled] to use the ASUS MyLogo2™ feature.
Quick Boot [Enabled]
Enabling this item allows the BIOS to skip some power on self tests (POST) while
booting to decrease the time needed to boot the system. When set to [Disabled],
BIOS performs all the POST items. Configuration options: [Disabled] [Enabled]
Full Screen Logo [Enabled]
This allows you to enable or disable the full screen logo display feature.
Configuration options: [Disabled] [Enabled]
4.6.2 Hard Disk Drives
Select Screen
Select Item
+- Change Option
F1 General Help
F10 Save and Exit
ESC Exit
Hard Disk Drives
1st Drive [USB: JetFlash Trans]
2nd Drive [USB: Kingston DataT]
Specifies the boot
sequence from the
available devices.
1st /2nd Drive [USB: JetFlash Trans]
These items specify the boot sequence from the available devices. The number
of device items that appears on the screen depends on the number of devices
installed in the system.
Configuration options: [USB: JetFlash Trans] [USB: Kingston DataT]