Univex Dual Mono Pre-Main Amplifier AM-77 - Manual (Page 27)

27
The following steps outline the procedure to label all the inputs and set the respective level offset.
The AM-77’s default labelling of its inputs starts from ‘Input 1’ and runs through to ‘Input 5’:
i. Press ‘MENU’ (RC1) on the RC-77.
ii. The display will flash ‘Labelling Input 1’.
iii. The 2 nd line of the display will commence with the first from a list of input labels (please see the
previous page for a list of input labels).
iv. Scroll using the ‘+/- buttons’ of the Volume (RC4).
iv. At the desired label, press ‘OK’ (RC7) to store the new label for that specific input.
v. The display will flash ‘Level Offset’. On the RC-77, using ‘+/-’ volume buttons, select the desired
level, press ‘OK’ (RC7) to confirm.
vi. The display will move onto ‘Labelling Input 2’.
vi. Repeat this process for the other inputs.
vii. One the last input, Input 5 has been programmed, press ‘OK’.
viii. Normal operation will resume at Input 5. If this is not the desired input, use SOURCE (F2) or (RC3)
to select the input of choice to resume listening.