Univex Dual Mono Pre-Main Amplifier AM-77 - Manual (Page 43)

43
Note: This function requires at least 2 x AM-77 synchronised pre-main amplifiers.
i. Power OFF via the ‘POWER’ (R12) mains switch at the rear of both AM-77s.
ii. Connect the cable from the ‘Sync Out’ connector (R8) of the ‘master’ amplifier to the ‘Sync In’
connector (R8) of the ‘slave’ amplifier. The amplifier with the cable connected to ‘Sync In’ becomes
‘slaved’ to the other and will automatically follow the ‘master’ AM-77.
iii Using a small flat blade screwdriver, move the ‘MODE’ switch (R5) to the left to select ‘M’.
iv. Using a small flat blade screwdriver, move the ‘INT/POWER AMP’ switch (R4) to the right to select
‘INT AMP’.
v. Repeat this process for the other AM-77.
vi. Power both AM-77s back on via the ‘POWER’ switch (R12).