Uniden BC350C - Manual (Page 31)

Deleting a Programmed Frequency
(programming "000.0000")
You can erase a programmed frequency in a channel. To do
this, find and display "000.0000", and then program
"000.0000" into its channel.
1. Find and display "000.0000" on the screen
You can choose either of two ways:
a. If there is an open channel in the scanner, find
"000.0000" in an open channel:
Press the desired bank key (Private, Police, or
Fire/EMS), and then [HOLD], and use [UP] and
[DOWN] to scroll through the bank to find an open
channel, "000.0000", then press [PROG]. "CH" is
displayed and it is blinking.
– OR –
b. If all channels are programmed, find "000.0000" from the
Search/Program Mode.
Every search band has one "000.0000" display included
between the band limits. It can be displayed only in the
Program Mode (after pressing [PROG] and "CH" is
blinking in the display).
1) Select Search band by pressing [BAND] in the Search
Mode, for example band 50-54.
2) Press [HOLD] to stop searching.
3) Press [PROG] to go into Program Mode.
4) Use [UP] or [DOWN] to display the lowest frequency
(50.0000) or the highest frequency (54.0000).
5) Press [UP] once for the highest frequency, or [DOWN]
once for the lowest frequency to display "000.0000" with
blinking "CH".
27
UB317Z (BC350C) 0916 9/16/03 12:43 PM Page 27