Uniden BC350C - Manual (Page 34)

If your BC350C is not performing properly, try the steps listed
below.
Scanner won’t work • Check the connections at both ends of
the AC Adapter.
• Turn on the wall switch of your room.
You could be using an outlet controlled
by the wall switch. Move the AC
Adapter to another wall outlet.
• Check the connections at both ends of
the DC cord or cigarette lighter cord.
• Check to see if the fuse is blown.
• Make sure the ignition key in your
vehicle is at the Accessory position.
• Make sure the power switch is turned
on.
• Check the antenna and its connection.
• Move the scanner.
• You may be in a fringe area. This may
require an optional multi-band antenna.
Check with your dealer or local
electronics store.
• Adjust the Squelch Control.
• Check the Antenna Connection.
• Review each channel's frequency to
see if it is still stored in memory and is
correct.
• Check and adjust Squelch (see
"Adjusting the Squelch" on page 18).
• Check the antenna connection.
• Check to see if all channels are locked
out.
• It is possible that none of the
programmed frequencies are active at
the time. Try the band search.
30
Troubleshooting
PROBLEM PROBLEM
Improper reception
Weather scan won't
work
Scan won’t stop
UB317Z (BC350C) 0916 9/16/03 12:43 PM Page 30