Uline CO2175 - Manual (Page 17)

Level & Install Unit 15
12 Level The Unit
Leveling Information
It is recommended that the unit is level.
1. Use a level to check
the levelness of the
unit from front to
back and from side
to side. Level should
be placed along top
edge and side edge
as shown
2. If the unit is not level, adjust the feet on the corners of the unit
as necessary (not available in CO29 models).
3. Check the levelness after each adjustment and repeat the
previous steps until the unit is level.
INSTALLATION TIP
If the room floor is higher than the floor in the cut-out opening,
adjust the rear feet to achieve a total unit rear height of 1/8" less
than the opening’s rear height. Shorten the unit height in the front
by adjusting the front feet. This allows the unit to be gently tipped
into the opening. Readjust the front feet to level the unit after it is
correctly positioned in the opening.
1
Turn Foot to Adjust
13 Install the Unit
Installation
1. Open the water supply valve in the main water source.
2. Plug in the power cord.
CLR2160 & CLRCO2175 Only
• Open the door and press the POWER icon. to turn the unit
OFF.
Note: If the unit is NOT turned OFF, water will immediately
start flowing into the unit when it is first plugged into the
electrical outlet.
• Test the drain system by pouring one gallon of water into
the ice bin. The water should drain freely and there should
be no leakage.
All Models
3. Gently push the unit into position. Be careful not to kink the
water supply line or entangle the electrical cord.
4. Re-check the leveling, from front to back and side to side. Make
any necessary adjustments. The unit’s top surface should be
approximately 1/8" below the counter top.
5. Remove the tape from the glass shelves and wipe out the inside
of the unit with a clean, water-dampened cloth.
Relocating the Shelves
Both the glass shelves in the refrigerator and the inner door
shelves can be moved to accommodate your bottles, cans and
containers.
Glass Shelves on Right-Hand Hinge Units
• Open door fully, grasp shelf firmly, lift front edge slightly, and
pull straight out.
• Choose new location and slide shelf onto the appropriate rib.
Glass Shelves on Left-Hand Hinge Units
• Pull shelf out about 6” to clear the wall’s molded protrusion.
• Tilt right-hand edge of shelf up.
• Keeping at this angle and hugging the right wall, pull the shelf
out.
• Choose new location and insert over ribs, tilting right-hand
edge up. Push in, then lower shelf onto ribs.
Door Shelves
• First pull shelf up at a 45° angle, then straight out (see Figure
39).
• Choose new location and line up on bosses. First push straight
in, then down at a 45° angle.