Univex SupraPlus Wireless Headset System - Manual (Page 9)

9 Questions? For fast, efficient Technical Support call: 800-544-4660 Ext. 5538
C. If you do not hear a dial tone
If you do not hear a dial tone, the Lifter may not be raising the handset high enough
or the Confi guration Dial may need adjusting.
1. Check the Lifter height adjustment by moving the Lifter Height Switch to a higher
position. See Section B and repeat steps 2 through 4 .
If you hear a dial tone, the lifter height is now set correctly. Please continue with
the next section “Mount the Lifter in Permanent Position”.
2 . If you still cannot hear a dial tone, you
will need to change the setting on
the Confi guration Dial. Using a coin or
paperclip, turn the Confi guration Dial
to a diff erent setting until you hear a
dial tone. If you still cannot hear a dial
tone, please call Technical Support at
800-544-4660 Extension 5538.
Confi guration
Dial
Position Indicator
Multiple settings might work with your phone; however, only one is the
optimal position.
If your handset falls off the phone base or does not re-
turn to its cradle when lowered, you will need to attach
the Extender Arm to the Lifter as described in the HL10
Additional Parts Kit.
Use the Extender Arm to Stabilize Handset
(if needed)
Note: If the side of the phone is curved, the protective cover on the side can be left on to improve fit.
1 . Remove the protective strips from the three mounting tapes on the underside of the Lifter.
2 . GENTLY place the Lifter on the desk phone in the optimum position as determined above.
Test the Lifter to verify positioning by pressing the Call Control Button on your headset to
activate the Lifter and listen for a dial tone.
3 . Press FIRMLY to adhere the Lifter to the desk phone.
D. Mount the Lifter in permanent position