Level the unit, Install the unit, Start-up for the first time – U-Line 1075WC User Manual

Page 7: Who to call

Advertising
background image

09/2008

7

www.U-LineService.com

1075WC

WARNING

SHOCK HAZARD — Electrical Grounding Required.

• Never remove the round grounding prong from

the plug and never use a two-prong grounding
adapter.

• Never use an extension cord to connect power to

the unit.

Go on to Level the Unit.

Level The Unit

LEVELING INFORMATION

Note: It is recommended that the unit is level.

1. Use a level to

check the levelness
of the unit from
front to back and
from side to side.
Level should be
placed along top
edge and side
edge as shown (see
Figure 8).

2. If the unit is not level, adjust the feet on the corners of

the unit as necessary (see Figure 9).

3. Check the levelness after each adjustment and repeat

the previous steps until the unit is level. Go on to
Install the Unit.

LEVELING TIP

If the room floor is higher than the floor in the cut-out
opening, adjust the rear feet to achieve a total unit rear
height of 1/8" less than the opening’s rear height. Shorten
the unit height in the front by adjusting the front feet.
This allows the unit to be gently tipped into the opening.
Readjust the front feet to level the unit after it is correctly
positioned in the opening.

Install The Unit

INSTALLATION

1. Plug in the power cord.

2. Gently push the unit into position. Be careful not to

entangle the electrical cord.

3. Re-check the leveling, from front to back and side to

side. Make any necessary adjustments. The unit’s top
surface should be approximately 1/8" below the
countertop.

Start-Up For The First Time

INITIAL START-UP

The unit is shipped with the control preset. No other
adjustments should be necessary at this time. For
information about Adjusting the Controller, see the Use
and Care Guide.

START-UP TROUBLESHOOTING

Problem

Unit does not appear to turn on when plugged in.

Solution

Make sure outlet has power (circuit breaker has not
tripped).

IMPORTANT

See the Use and Care Guide’s Troubleshooting Guide for
more solutions.

Who to Call

SERVICE INFORMATION

If the need for service arises, call the U-Line Customer
Care Center directly @ 800-779-2547. To ensure accurate
assistance, please have your Model Number and Serial
Number and an explanation of the problem. The Model
and Serial Number plate is located inside unit at upper
right hand corner.

If you need to locate a service company, you can go online
at www.U-LineService.com and search for a service
company by zip code.

Check

Level

ULIN_1021_A

Figure 8

Figure 9

Turn Foot to Adjust

Advertising