Univex TRAX353 - Manual (Page 50)

Page 50
How Do I Use It?
• After entering a couple of characters, the names that
match the string appear in a list.
• Tap to open the list of results before it
appears automatically.
4. Pick the street from the list.
5. Enter the house number:
1. Tap .
2. Enter the house number on the keyboard.
3. Tap to finish entering the address.
6. A list appears with the matching addresses. Tap the desired
one.
7. The map appears with the selected point in the middle. Tap
(Simple mode) or
(Advanced mode) from the Cursor menu. The route is then
automatically calculated, and you can start navigating.
Entering an address without knowing the
district/suburb
Long roads can run across several districts or suburbs. You may not know
if a particular house number is in which of them. In this case, follow the
instructions below:
The procedure is explained starting from the Navigation menu.
1. Tap the following buttons: (Simple mode), or
, (Advanced mode).
2. By default, TRAX353 proposes the country/state and settlement
where you are. If needed, tap the button with the name of the
country/state, and select a different one from the list.