UTStarcom CDM1450 - Manual (Page 41)

80 81
SETTINGS SETTINGS
VOICE COMMANDS
VR Results
The “VR Results” option will allow you to choose if the Command
System prompts you with a list of potential matches.
1.
Press Left Soft Key [Menu], then press “Settings”.
Press “Others”, then press “Voice Commands”.
2. Press “VR Results”.
3. Select “One” or “Three Best”, then press . Press Left Soft
Key [Select] to save the setting.
Voice calibration
Voice Calibration is the process of optimizing the voice recognition
software to your voice. Voice Calibration requires that you make
recordings of your voice, which are then used to customize the voice
recognition system. This will take a few minutes and you should be in a
quiet environment for optimum training.
1.
Press Left Soft Key [Menu], then press “Settings”.
Press “Others”, then press “Voice Commands”.
2.
Press “Voice calibration”.
3.
Select “Words calibration” or “Digits calibration”. You will be
prompted to speak the words listed on the screen. Say each word as
you are prompted.
Prompts
The prompts settings, “Mode” or “Timeout”, will allow you to set how
you are notified by the voice command system and the duration in
which you can respond. To access “Prompts:”
1.
Press Left Soft Key [Menu], then press “Settings”.
Press “Others”, then press “Voice Commands”.
2.
Press “Prompts”.
3. Select “Mode“ or “Timeout”.
4. Press , then press the Left Soft Key [Select] to save the
setting.
Number Format
1.
Press Left Soft Key [Menu], then press “Settings”.
Press “Others”, then press “Voice Commands”.
2. Press “Number Format”.
3. Select “Accept Any“ or “North America”.
• Mode: Select “Prompt” or “Tones Only”.
• Timeout: Select “5 sec” or “10 sec”.
• Accept Any: Processes phone numbers matching any numbering plan (a
specification of the number of digits and other phone-number
parameters)
• North America: Processes only those phone numbers that are valid for
the numbering plan of the specified region. Specifying the
numbering plan improves the recognition rate.
071012_1450M-EN_REV01.indd 80-81 071012_1450M-EN_REV01.indd 80-81 2007.12.17 10:21:8 AM 2007.12.17 10:21:8 AM