Uniden UH088SX - Manual (Page 5)

Controls/Indicators/Connections
1.
2. -These controls are used to select the desired
communication channel.
3.
Turns the uh088sx power ON or OFF and adjusts the volume.
Eliminates background noise in the absence of an incoming spiral.
4. Press to transmit and release to receive.
5. - Press to transmit SELCALL codes, it functions on condition that
SELCALL option is installed.
6.
Press this button momentarily to choose semi-duplex opeartion for channels 1 through 8.
7. Switches operation between OPEN SCAN and
GROUP SCAN Mode.
8. - Press to activate scanning or press and hold to enable Seek Mode
OS/GS Scanning.
LIQUID CRYSTAL DISPLAY (LCD) PANEL - Indicators for TX, CAL, MEM, TSQ, GS (OS), SCN
PRI, Channel Number, Frequency, Signal Strength Level (S), Transmit Power Level (RF),CTCSS Code
and DUP.
UP/DOWN CHANNEL SELECTOR
ON/OFF, VOLUME & SQUELCH CONTROLS
ON/OFF & Volume Control (Centre Knob)
Squelch Control (Outer Ring)
PUSH-TO-TALK (PTT) - SWITCH -
TONE CALL CONTROL BUTTON
DUPLEX Control
OPEN SCAN/GROUP SCAN CONTROL (OS/GS)-
SCAN CONTROL (SCAN) Normal OS/GS
3
UNIDEN UHF CB Transceiver
uh088sx
CONTROLS
10
9
8 7 6
191
2
3
5
4