Uniden UH088SX - Manual (Page 6)

9. MEMORY CONTROL (MEM) -
10. TONE SQUELCH CONTROL (TSQ) -
10 Secondary function: Continuous Tone Coded Squelch System (CTCSS)
11. Channel Indicator
12. Scan Indicator (SCN)
13. Priority Indicator (PRI)
14. Continuous Tone Coded Squelch System (CTCSS) Code
15. Frequency Indicator
16. RECEIVE SIGNAL/ RF LEVEL indicator (S/RF)
17. DUPLEX Indicator (DUP)
18. TRANSMIT indicator (TX)
20. CALL Indicator (CAL)
21. MEMORY Indicator (MEM)
22. GROUP SCAN Indicator (GS)
Places channel numbers into the memory scan list (OS or GS).
Controls Tone Squelched operation (quiet Mode) on condition that
SELCALL option is installed.
- is a feature that allows a
group to talk to each other without hearing other users on the same channel.
- Indicates the channel number currently selected. On TX SELCALL usage the Channel
Indicator becomes a Memory location indicator.
- SCN icon appears when normal Scan mode is activated. When Seek mode Scanning is
selected the SCN icon blinks.
- Indicates that priority channel is active when continuously lit or flashes when it is
regularly being checked for activity while GS scanning.
- Indicates the CTCSS code selected for the
current channel.
- Shows the frequency of the current selected channel.
- Indicates the relative signal strength level when receiving (S)
or the relative transmit power (RF) when transmitting.
- The DUP icon appears when duplex operation is selected.
- TX appears when the PTT button on the microphone is pressed and the radio is
transmitting. The RF icon also appears at this time.
- The CAL icon appears when the uh088sx radio is called using SELCALL. It also
appears when SELCALL codes are being transmitted.
- MEM appears when the displayed channel is programmed either in GS or
OS Memory.
- The GS icon appears when Group Scan Mode is activated. Open scan is
indicated by the absence of the GS icon.
INDICATORS
19. TONE SQUELCH indicator (TSQ) - The TSQ icon will appear when the selected channel is set to operate in
Quiet Mode, or flashes when the radio is called using SELCALL.
Controls/Indicators/Connections
4
UNIDEN UHF CB Transceiver
12 11
13
12
14
15
16
21 20 22
18
17
19