Vizio RP56 - Manual (Page 31)

VIZIO RP56 User Guide
040330 28
3 Getting Started
Turning your DLP TV On and Off
1. Plug the power cord into an AC wall socket. The POWER indicator on the front panel will light
green.
2. Press the POWER button on the front panel or the POWER button on the Remote Control to
power on the DLP TV. The LAMP STATUS indicator will start flashing while the lamp heats and
once the lamp is warm enough the indicator will stay lit green and the picture will begin to appear
on the screen.
3. When the DVP TV is on, press the POWER button on the front panel or the POWER button on
the Remote Control and a message will appear on the screen warning you that you are about to
power off the DLP TV. This is because once the DVP TV has been turned off you cannot turn it
on again until at least 45 seconds later as a protection feature for the lamp which will be damaged
if it is turned on too soon after being on. The LAMP STATUS indicator will start flashing until the
protection time has passed and then the indicator go off and the DLP TV will be in the standby
mode.
Adjusting your DLP TV Settings
Volume
To increase the volume, press and hold the VOL + button on the front panel or Remote Control until the
desired level is reached.
To decrease the volume, press and hold the - VOL button on the front panel or Remote Control until the
desired level is reached.
TV Channels
To step up through the available TV channels press the CH + button on the front panel or Remote
Control once for the next channel or hold it depressed until the desired channel is reached.
To step down through the available TV channels press the - CH button on the front panel or Remote
Control once for the previous channel or hold it depressed until the desired channel is reached.
Mute
Press the MUTE button on the Remote Control to turn off the sound; press the button again to cancel
the MUTE feature and turn the sound on.
Sleep
The Sleep Timer can be set to turn the DLP TV off in 30, 60, 90 or 120 minutes.
Press the SLEEP button on the Remote Control once and the display on the screen will show the timer
is off. Press it again and the display will change to 30 minutes, press it again and the display will
change to 60 minutes, again for the display to show 90 minutes and again for 120 minutes. The timer
will start once the display disappears. If you want to cancel the Sleep Timer, keep press the SLEEP
button to get to 120 minutes and then press it once more so the display shows off.
Wide
Using this feature you can watch video content in Stretch, Center, Panoramic or Zoom mode.
Press the WIDE button on the Remote Control and switch between the modes.