Vizio P42 User Manual
Page 11
Version - 2/21/2005
10
www.vizioce.com
1.10.1 - Key Remote Control Functions
1.
SETUP - This button starts all programming sequences.
2.
Remote LED – Blinks when the remote is being programmed or is
sending a signal to your Plasma Display.
3.
POWER - Press this key to turn the Plasma Display On from
Standby mode. Press it again to return to the Standby mode.
4.
AUX – This button selects a programmed component.
5.
CBL – This button selects a programmed cable TV set-top box or selects a programmed
satellite TV set-top box.
6.
VCR – This button selects a programmed VCR.
7.
TV – This button selects a programmed TV. Pre-programmed for the VIZIO P42 Plasma
TV.
8.
Number Button Pad – These buttons select a channel or
password.
9.
MUTE – This button turns the sound on and off.
10.
100/Enter – This button enters a channel number greater than 100
in TV mode. Additionally, it works as an ENTER button in other
video modes.
11.
VOL (+ or -) – These buttons turn volume up or down.
12.
LAST – This button recalls the previously viewed channel.
13.
INPUT – This button changes the input source.
14.
CH (+ or -) – These buttons change the channels up or down.
15.
WIDE/GUIDE – This button cycles through standard and
widescreen viewing modes or accesses programming guides, such
as the one that comes with a satellite dish. GUIDE does not work
in TV mode.
16.
FAV/EXIT – This button exits the component, guide or OSD
menus. Additionally, it retrieves your favorite channels in TV
mode.
dcfe
- These buttons navigate the on-screen display (OSD)
menus.
17.
SELECT – This button works to select your chosen options in on-screen display (OSD)
menus.
18.
INFO – This button turns the image and system information display On or Off.
19.
MENU – This button is used to select the OSD menu pages in the following sequence:
PictureDAudioDSourceDGraphicDTVDClockDSetup