Vivitar VIVICAM X027 - Manual (Page 6)

5
When powering the camera ON for the first time the camera will take you through the INITIAL
CAMERA SETUP.
Powering the Camera ON
1) Batteries
Make sure the batteries have been inserted properly into your digital camera, according to
the polarity shown inside the battery compartment.
Use 3x AAA (1.5v) batteries. Alkaline batteries are recommended. (Batteries not included.)
Note:

Remove the batteries from the camera when not in use for an extended period.

Do not mix alkaline and non-alkaline batteries.

Some features, such as Flash, will not work if the battery power level is low.

When the battery power is low the battery icon turns red and the camera will
automatically turn off a few seconds later.

The energy status of the power is displayed on LCD as shown below:
Full battery power Medium battery power Low battery power
2) SD Card
Make sure an SD card has been properly inserted into your camera. (SD card not included.)
To properly insert the SD Card:
Push the SD card into the slot in the direction shown on the camera (see SD icon by the SD
card slot). Push the SD card until you hear a slight clicking sound. This indicates the SD
card has been inserted correctly.
Note:

After the camera is powered on, an SD icon will appear on the LCD display. If you do not
see the SD icon on the display, please check if the card was inserted properly.

Make sure the SD card is not locked (check the lock switch on the side of the SD card). If
the SD card is locked this will prevent the camera from saving captured photos to the SD card.
3) Power On
Press the POWER button to turn on the camera.