Vizio VO47L FHDTV10A - Manual (Page 31)

VIZIO VO47L FHDTV10A User Manual
Version 11/7/2007 31
www.VIZIO.com
Chapter 3 Chapter 3 Chapter 3 Chapter 3 Setting Up to Watch Television Setting Up to Watch Television Setting Up to Watch Television Setting Up to Watch Television
For ‘Preparing Your LCD HDTV for Wall Mounting’, see page 6.
3.1 3.1 3.1 3.1 Basic Basic Basic Basic LCD HDTV LCD HDTV LCD HDTV LCD HDTV Start Up Start Up Start Up Start Up
1. Connecting the Power Cable
Connect the power cord to the power cord connector on the back of the LCD HDTV, and then
plug the power cord into an AC wall socket.
2. Connect Audio and Video Cables to the LCD HDTV
(see pages 16 ~ 29 for detailed steps)
3. Turning Power On
Once all the components are connected, press the Power ON button
on the side of the LCD HDTV, or press the Power ON (Red) button on
the remote control.
4. Select Input Source
Select the Input Source for the LCD HDTV by pressing the INPUT
button on the side of the TV or using the Input button on the remote
control. Pressing this button will cycle you through the following
options: TV, AV1, AV2, Component 1, Component 2, RGB, HDMI1,
HDMI2, HDMI3 and HDMI4.
5. Using DTV and TV with an Antenna or Cable
If an antenna or cable source is connected to the DTV/TV input, you will need to select TV using
the INPUT button on the remote control or the side of the LCD HDTV, or directly by pressing the
TV button on the remote control, and Auto Scan for the available TV channels.
a. The screen will show ‘snow’ and the first Initial
Setup OSD panel.
Press the OK button on the remote control.
Note: If you do not see this option within the OSD, you might
have selected the wrong input in the previous steps and you will
need to repeat step 4 (above) to select the correct input source.