Vision Fitness X6100 - Manual (Page 9)

9
6
STEP
OPTIONAL
5
STEP
Dual-Action
Axle Cover
Link Arm
Covers
5
STEP
• On the right side, slide the dual
action axle cover into place on the axle
located on the console mast. Slide a
wavy washer (M25.5x34x2t) onto the
axle. Slide the right dual action arm
into place on the axle. Fix in place with
the washer (M8x35x2t) and locknut
(M8). Cover with the included nut cap.
• Make sure the bushing is in place in
the socket joint of the lower link arm.
Connect the lower link arm to the dual
action arm with a screw (M8x30L),
washer (M8.2x16.1.5T), and nut
(M8). Tighten with the 6
MM Allen wrench
and 13 MM wrench.
• Position the link arm cover into place
over the joint of the lower link arm and
Secure the two pieces of the cover
together by inserting and tightening a
panhead screw (M4x15L). Connect
the cover to each side of the lower link
arm with a washer (M5x10x1t) and
screw (M5x10L).
• Repeat these steps on the left side.
BLACK BAG
6
STEP
• NOTE: Elliptical Trainer cannot be
folded with the child safety guards in
place.
• Line up the grooves on the child
safety guards with the screws on the
guide rails. Slide the safety guard into
place on the guide rails. Tighten the
screws with the Phillips screwdriver to
lock in place.
SAFETY GUARDS
O P T I O N A L