Venturer ASR150 - Manual (Page 12)

11
The following checks will assist in the correction of most problems which you may encounter with your
system.
PROBLEMS
No power.
No sound.
No sound from one channel or
unbalanced left and right
volume.
Reversed left and right sound.
The centre speaker or the
surround speakers give no
sound
The remote control does not
function.
SOLUTIONS
• Check that the AC power cord is connected.
• Press the VOLUME + button to increase volume.
• Ensure the MUTE button is not pressed on the remote control.
• Ensure the INPUT SOURCE selection is correct.
• Check the speaker connections of the inoperative channel.
• Check the speaker cord connection and speaker location.
• Adjust individual speaker volumes (see page 10).
• Check the speaker connection for proper phasing.
• Check that the speaker connections are correct.
• The current mode does not support surround sound.
• Remove any obstacles between the remote control and the
unit.
• Use the remote control near the unit.
• Point the remote control at the remote sensor on the unit.
• Replace the battery in the remote control with new one.
• If there is a clear plastic strip sticking out from the rear of the
remote control, pull it out.
Power consumption : 60W
Power requirements : AC ~ 100V 50/60Hz (Japan)
AC ~ 110V/120 - 220/240 50/60Hz (Other countries)
AC ~ 120V 60Hz (USA and Canada)
AC ~ 220V 50Hz (Hong Kong and China)
AC ~ 230-240V 50Hz (Europe)
AC ~ 240V 50Hz (Australia)
Specifications and external appearance are subject to change without advance notice due to
continuous product improvement.
TROUBLE SHOOTING GUIDE
OPERATING VOLTAGE
811-A15091-010 Printed in China