Venturer ASR150 - Manual (Page 6)

5
FUNCTION CONTROL
(Continued)
REMOTE CONTROL
1. GAME button
Press to select the GAME
sound input source.
2. STANDBY/ON button
Turns the unit ON, or puts the
unit into STANDBY mode.
3. DVD button
Press to select the DVD sound
input source.
4. JAZZ button
Press to select the JAZZ of
equalization mode.
5. POP button
Press to select the POP of
equalization mode.
6. DOWN button
Press to decrease the volume
of individual speaker.
7. MUTE button
Instantly turns off the sound.
Press again to restore the
sound.
8. VOLUME + / – button
Adjust the volume and the
level of all speakers.
9. AUX button
Press to select the AUX
sound input source.
10. FLAT button
Press to select the FLAT of
equalization mode.
11. CLASSIC button
Press to select the CLASSIC
of equalization mode.
12. ROCK button
Press to select the ROCK of
equalization mode.
13. RESET button
Press to adjust all speakers
to the normal level.
14. UP button
Press to increase the volume
of individual speaker.
15. SOUND button
Press to select the speaker
mode.
16. 2.1 / 5.1 CH button
Press to select the listening
mode in 2.1 or 5.1 channel.
• Point the Remote Control at the REMOTE SENSOR located on the unit.
• When there is a strong ambient light source, the performance of the infrared REMOTE SENSOR
may be degraded, causing unreliable operation.
• The recommended effective distance for remote operation is about 6 meters (19 feet).
TO CHANGE REMOTE BATTERY
1. Open the battery door. 2. Insert one CR2025 (3V)
size battery.
ATTENTION
Take out the PVC sheet before
operating the Remote
Control.
When battery become weak, the operating distance of the Remote Control is greatly reduced and you
will need to replace the battery.
NOTE : If the Remote Control is not to be used for a long time, remove the battery to avoid damage
caused by battery leakage corrosion.
WARNING : Do not dispose of batteries in fire, batteries may explode or leak.
CAUTION : Danger of explosion if battery is incorrectly replaced. Replace only with the same or
equivalent type.
USING THE REMOTE CONTROL CORRECTLY
BATTERY REPLACEMENT