Problems with your wine cellar – Vinotemp VT-36 User Manual

Page 17

Advertising
background image

17

1 7 6 3 1 S . S u s a n a R o a d , R a n c h o D o m i n g u e z , C A 9 0 2 2 1

[email protected]

PROBLEMS WITH YOUR WINE CELLAR

You can easily solve many common wine cellar problems, saving you the
cost of a possible service call. Try the suggestions below to see if you can
solve the problem before contacting Vinotemp at [email protected].

TROUBLESHOOTING GUIDE

PROBLEM

POSSIBLE CAUSE

Wine cellar does
not operate

Not plugged in.

Using wrong voltage.

The circuit breaker tripped or there is a blown
fuse.

Wine cellar is not
cold enough

Check the temperature control setting; external
environment may require a higher setting.

The door is opened too often.

The door is not closed completely.

The door seal does not seal properly.

The wine cellar does not have the correct
clearances to operate efficiently and safely.

Turns on and off
frequently

The room temperature is hotter than normal.

A large amount of contents has been added to
the appliance.

The door is opened too often.

The door is not closed completely.

The temperature control is not set correctly.

The door gasket does not seal properly.

Vibrations

Check to see that the wine cellar is level.

Wine cellar seems
to make too much
noise

The rattling noise may come from the flow of the
refrigerant, which is normal.

As each cycle ends, you may hear gurgling
sounds caused by the flow of refrigerant in your
unit.

Contraction and expansion of the inside walls
may cause popping and crackling noises.

The appliance is not level.

Door will not close
properly

The wine cellar is not level.

The doors were not properly installed.

The seal is weak.

The shelves are out of position.

The light does not
work

Not plugged in.

The circuit breaker tripped or a blown fuse.

The light switch is “OFF”.

Advertising