Electrical connection – Vinotemp VT-36 User Manual

Page 8

Advertising
background image

8

W

W

W

.

V

I

N

O

T

E

M

P

.

C

O

M

ELECTRICAL CONNECTION

WARNING: Improper use of the grounded plug can result in the risk of

electrical shock. If the power cord is damaged, have it replaced by an

authorized products service center.

This unit should be properly grounded for your safety. Don’t use
extension cords or an adapter.

Do not kink or pinch the power supply cord.

The cord should be secured behind the wine cooler and not exposed
or dangling to prevent accidental injury.

The power cord of this unit is equipped with a 3-pin plug which fits
with 3-pin wall outlets to minimize the possibility of electrical shock.
Do not under any circumstances cut or remove the ground wire
from the power cord supplied.

Have the wall outlet and circuit checked by a qualified electrician to
make sure the outlet is properly grounded.

When a standard 2-pin wall outlet is encountered, it is your
responsibility to have it replaced with a properly grounded 3-pin
wall outlet.

This unit requires a standard 115V—60HZ. Follow the voltage
rating, for this provides the best performance and also prevents
overloading house wiring circuits that could cause a fire hazard
from overheating.

Never unplug the appliance by pulling the power cord. Always grip
the plug firmly and pull straight out from the outlet.

Repair or replace immediately all power cords that have become
frayed or damaged. Do not use a cord that shows cracks or
abrasion damage along its length or at either end. When moving
the appliance, be careful not to damage the power cord.

EXTENSION CORDS: Because of potential safety hazards under

certain conditions, it is strongly recommended that you do not use

an extension cord with this appliance. However, if you must

use an extension cord it is absolutely necessary that it be a

UL/CUL-Listed, 3-wire grounding type appliance extension cord

having a grounding type plug, 3-pin wall outlet, and the electrical

rating of the cord be 115 volts and at least 10 amperes.

Advertising