Vector SLH100V - Manual (Page 7)

6
2. Insert the DC pin in the charging port on the side of the light.
3. Charging time using this method is approximately 5 to 6 hours.
4. When charging is complete, remove the power cord.
Note: When using a vehicle’s 12 volt DC accessory outlet as a charging source, be
aware that some vehicles require the ignition be turned on to power the accessory outlet.
OPERATING INSTRUCTIONS
Using the Spotlight
The HID Spotlight is operated by the switch located on the handle of the unit. The
Charging/ON LED indicator will light blue when the unit is turned ON.
Using the Adjustable Work Stand
Set the hands-free adjustable work stand to the desired position; the stand will click
into position.
CARE AND MAINTENANCE
CAUTION
To reduce the risk of burns and avoid damage to the unit, make sure
all power switches are in the OFF position, all adapters are unplugged
and the unit has been allowed to cool down before replacing the
battery and performing any care and maintenance on the exterior of
the light.
All batteries lose charge with time. AC recharge is recommended after each use or
every two months when not in frequent use.
If the unit gets dirty, gently clean the outer surfaces of the Spotlight with a soft cloth
moistened with a mild solution of water and detergent. Periodically inspect the
condition of recharge adapters, connectors, and wires. Replace any components
that may have become worn or broken.
Replacement Parts
The sealed lead acid battery is the only user-replaceable part in this light and it is
available through Vector Products, Inc. These can also be purchased from popular
automotive parts suppliers nationwide. Contact Vector Products, Inc.’s Technical
Support Department for replacement parts (including replacement adapters and
cords) and any additional information that you may need. They may be reached toll
free at (800) 544-6986.
SLH100V_ManualEN 6/25/07 11:02 AM Page 6