VTech I6717 - Manual (Page 6)

www.vtechphones.com 3
In
sta
lla
tio
n
B
as
ic
o
pe
ra
tio
n
• Use only the
VTech battery and
AC power adapter
(or equivalent)
supplied with
this telephone.
To obtain a
replacement, visit
our website at
www.vtechphones.
com or call
1 (800) 595-9511.
In Canada go to
www.vtechcanada.
com or call
1 (800) 267-7377.
• This power unit
is intended to be
correctly oriented
in a vertical or floor
mount position.
The prongs are not
designed to hold
the plug in place if
it is plugged into a
ceiling, under-the-
table or cabinet
outlet.
Installation
Plug power adapter into an electrical
outlet not controlled by a wall switch.
Plug the telephone line cord
into a telephone jack.
Telephone base installation
It is recommended to install the telephone base away from any electronic equipment and appliances
such as personal computers, computer routers, television sets, microwave ovens, and refrigerators.
Avoid excessive heat, cold, dust or moisture. When a location is selected, install the telephone base
and the charger as shown below.
• Plug the connector into the power jack at the bottom of the telephone base. Route cords through
slots and plug the power adapter into an electrical outlet not controlled by a wall switch.
• Plug one end of the telephone line cord into the telephone line jack at the bottom of the telephone
base. Route the telephone line cord through slot, then plug the other end of the cord into the modular
wall telephone outlet.