Vincent, Rre ea ar r v viie ew w – Vincent Audio SV-234 User Manual

Page 28

Advertising
background image

2

28

8

Vincent

9.

SPEAKER: Loudspeaker terminals
At these output sockets with threaded terminals
one or two pair(s) of stereo loudspeakers can
be connected. Speaker cable with 4 mm banana
plugs can be used. Please take note of the infor-
mation given in the section "Installation", if two
pairs of loudspeakers will be connected to the
amplifier.

10. INPUT ("LINE1"..."LINE4"): Terminal

for stereo audio signals of the source
equipment

Here you find four stereo RCA

input sockets for source equipment with analo-
gue stereo (line level) audio output.

11. MAIN INPUT ("LINE5"): Main Amplifier

Input This is for the connection of a stereo
preamplifier or source equipment with a pream-
plifier output. Note that no high level output
should be connected from a stereo source to
“LINE5”. This input must also not be connected
to the neighbouring preamplifier output, “PRE
OUTPUT” (14).

12. INPUT "BALANCED": XLR-Input

These are the input sockets for one stereo
audio source equipped with XLR output sockets.

13. REC OUTPUT: Output connectors

assigned to a recording device
If desired, you can connect a recording device

like a CD recorder or a tape recorder to this
output. The stereo signal of this output is identi-
cal to the output signal of the selected audio
source at one of the inputs "LINE1"..."LINE4".
The signals of the inputs "BALANCED" and
"LINE5" are not available for recording at
this output!

14. PRE OUTPUT: Preamplifier Output

If one of the inputs "LINE1"..."LINE4" (10) or the
input "BALANCED" (12) is selected, the "PRE"
output can supply two additional main amplifier
channels with the preamplified stereo audio
signal of the selected source. The output must not
be connected to the neighboring power ampli-
fier input "LINE5 MAIN INPUT" or to the high
level input of another HiFi component.

15. POWER CONTROL (12V)

These jack connectors (3,5 mm) send and
receive the signals for the standby control
(12V Trigger).

16. AC power connector and fuse holder

To establish the power supply, connect the plugs
of the power cable to the device and to a 230V
AC wall outlet. The small plastic housing beneath
the plug opening holds the fuse. Refer to the
security precautions.

R

RE

EA

AR

R V

VIIE

EW

W

1

11

1

1

16

6

1

14

4

1

12

2

1

15

5

9

9

1

10

0

1

13

3

Advertising