VTech ip8301 - Manual (Page 11)

11
Base Layout
7. RESET – Press the reset button
while the telephone base is
powered on to reboot the
system. Press and hold the
reset button for 10 seconds
while the telephone base is
powered on to reset the system
PIN to the default (0000), clear
the call history, and perform a
software reboot.
8. TELEPHONE LINE JACK –
Connects to your home
telephone line for making and
receiving calls.
9. ETHERNET – Connects to your
broadband router to access the
Internet.
10. POWER JACK – Connects to
the power adapter which plugs
into an electrical outlet to
provide power to the base.
1. FIND HANDSET – If you
misplace a handset, press this
button to make the handset
ring. To stop the ringing, press
OFF on the handset, or press
FIND HANDSET on the
telephone base again.
2. POWER – A steady red light
indicates the base is powered
on.
3. VWMI – A blinking orange light
indicates that there are new
voicemail messages. If the light
is off, there are no new
voicemail messages.
4. LINE IN USE – A blinking
orange light indicates that there
is an incoming call. A steady
orange light indicates that the
telephone line is in use. If the
light is off, the telephone line is
not in use.
5. INFO – A blinking orange light
indicates that the telephone has
an IP address from the
broadband router, but cannot
communicate with the Internet.
A steady orange light indicates
that the base is communicating
with the Internet and is ready to
be used. If the light is off, the
base has failed to obtain an IP
address from the router.
6. INTERNET – A steady or
flickering orange light indicates
the base is properly connected
to the router.
B
a
s
e
L
a
y
o
u
t