VTech 2420 - Manual (Page 12)

12
Enter Base ID Code
1.
After charging the Handset, remove
it from its Charge Cradle, the screen
will display:
2.
Press NEW, then enter the 15 digit
Base Unit ID code, located on the
underside of the Base Unit.
3.
Press OK. The Handset will display:
PLEASE WAIT!!
4.
Wait approximately 15 seconds.
The Handset will display:
FOUND BASE
If the Handset displays: BASE
BUSY TRY LATER, this indicates
that the system is in use. Wait until
the Base Unit is in the idle (on hook)
mode, and repeat steps 2 to 4.
NOTE: Occasionally, it may take longer
than 15 seconds for the Handset to confirm
registration to the Base Unit. This is
normal.
Congratulations! You can now enjoy the
benefits of your multi-Handset system.
Registration and Operation
Getting Started