VTech LS6126-3 - Manual (Page 6)

www.vtechphones.com 3
G
ett
in
g s
ta
rte
d
B
as
ic
o
pe
ra
tio
n
Getting started
If the handset
wll not be used
for a long tme,
dsconnect and
remove the battery
to prevent possble
leakage.
To purchase
replacement
batteres, vst our
webste at www.
vtechphones.
com or call
1 (800) 595-9511.
In Canada, go to
www.vtechcanada.
com or call 1 (800)
267-7377.
•
•
Battery installation and charging
Install the battery as shown below. After nstallng the battery, you mght be able
to make and receve short calls. For best performance, charge the handset for at
least 16 hours before use. When the battery power s low, the handset wll beep,
LOW BATTERY wll be dsplayed and will flash on the handset screen. Place
the handset n the telephone base or charger to charge the battery when not n
use. See the table on page 52 for battery operatng tmes.
If the battery s depleted, t may take approxmately four mnutes to charge the
handset before t can resume screen dsplay. The screen wll contnue to dsplay
LOW BATTERY untl the battery has been charged for approxmately one hour.
1 2 3 4
FLASH CLEAR
SELECT MENU
CID
VOL
Charge lght
Plug the battery
securely nto the plug
nsde the handset
battery compartment,
matchng the color-
coded label.
Place the battery wth
the label THIS SIDE
UP facng up and the
wres nsde the battery
compartment.
Align the cover flat
aganst the battery
compartment, then
slde t upwards untl
t clcks nto place.
Charge the handset
by placng t n the
telephone base
or charger. The
CHARGE lght wll be
on when the handset
s chargng.