Vent-a-Hood 812-3450-0 (Hickory) - Manual (Page 6)

5
Step 5
With the help of a friend, set the unit
upright. Try to minimize stress on the legs
of the grill.
Step 6
Attach hood stops to the outside back of
the body using 6 x 12 mm Phillips hex
head screws. Thread screws into welded
nuts and tighten until secure.
Step 7
Attach the hinges (with the spine side out)
to the outside back of the body using 6 x
12 mm Phillips hex head screws. Thread
screws into welded nuts but do not
tighten at this point. Place lid over the
body and attach hinges to the outside
back of the lid using 6 x 12 mm Phillips
hex head screws. Thread screws into
welded nuts. Tighten all hinge screws on
lid and body until secure.
Step 8
Attach handle to the lid using 5 x 75mm
screws, flat washers, spacers, spring
washers and nuts. The heads of the
screws should be slightly recessed into
the wooden handle when fully tightened.
Hood
Stop
Hood
Hinge
6 x 50mm
Screws