Vent-a-Hood 812-3450-0 (Hickory) - Manual (Page 7)

6
Step 8
To attach all four vent covers to insides of
lid and body, place vent cover on the
inside of the unit with the adjustment tab
sticking through one of the air vent holes.
Using 6 x 12mm screw and nut, secure
vent cover to the unit. Do not overtighten
the nut as this will make the vent difficult
to open and close.
Step 9
Attach three wooden slats to each set of
side shelf supports using 6 x 50mm
bolts and 6 x 3.5mm nuts
.
Step 10
Install heat indicator in lid by aligning
tabs on heat indicator with slots in the
opening on front of lid. Insert and turn 4
revolution until the word “IDEAL” on heat
indicator is at top of dial.
BRINKMANN D ALLAS,
TX 75244
BRINKMANN
DALLAS, TX 75244
Wooden
Shelf Slat
Leg/Shelf
Bracket
6 x 12mm
Phillips Hex Bolt
6 x 5mm nut