Transparent mode scenarios chapter 4. routing 123 – D-Link DFL-2500 User Manual
Page 123
Switch Route:
Similar as shown in the previous example. Set up the switch route with the new interface group created earlier.
Configure the rules:
1.
Go to Rules > New Rule
2.
The Rule Properties dialog will be displayed
3.
Specify a suitable name for the rule, for instance HTTP-LAN-to-DMZ
4.
Enter following:
•
Action: Allow
•
Source Interface: lan
•
Destination Interface: dmz
•
Source Network: all-nets
•
Destination Network: 10.1.4.10
5.
Under the Service tab, choose http in the Pre-defined control
6.
Click OK
7.
Go to Rules > New Rule
8.
The Rule Properties dialog will be displayed
9.
Specify a suitable name for the rule, for instance HTTP-WAN-to-DMZ
10. Enter following:
•
Action: SAT
•
Source Interface: wan
•
Destination Interface: dmz
•
Source Network: all-nets
•
Destination Network: wan_ip
11. Under the Service tab, choose http in the Pre-defined control
12. Under the Address Translation tab, choose Destination IP Address and enter 10.1.4.10 in the New IP
Address control.
13. Click OK
14. Go to Rules > New Rule
15. The Rule Properties dialog will be displayed
16. Specify a suitable name for the rule, for instance HTTP-LAN-to-DMZ
17. Enter following:
•
Action: Allow
•
Source Interface: wan
•
Destination Interface: dmz
•
Source Network: all-nets
•
Destination Network: wan_ip
18. Under the Service tab, choose http in the Pre-defined control
19. Click OK
Web Interface
Configure the interfaces:
4.6.6. Transparent Mode Scenarios
Chapter 4. Routing
123