Vanguard Heating SBVRBP - Manual (Page 7)

7 106707
OWNER’S MANUAL
For more information, visit www.desatech.com
CAST IRON STOVE
AND B-VENT
BURNER SYSTEM
ASSEMBLY
Continued
INSTALLING B-VENT
BURNER SYSTEM INTO
STOVE BODY
1. Carefully lift burner system and place
into stove body from the rear of stove.
2. Place the left, right, and center grate tops
into the top of stove body.
Figure 15 - Installing Burner System Into
Cast Iron Stove Body
LO H I P IL O
T O F F O N
Cast Iron
Stove Body
Burner
System
NOTICE: If installing blower in an
existing stove burner system with
gas connections, shut off gas
supply and disconnect heater
from gas supply. Contact a quali-
fied service person to do this.
INSTALLING OPTIONAL
BLOWER ACCESSORY
1. Remove 4 hex screws securing rear cover
to back of stove body (see Figure 16).
2. Separate bottom cover from rear cover
by loosening the 8 mounting screws
(see Figure 16).
3. Align the holes in the top mounting tabs
of blower with the holes in wall of rear
cover. Using the 4 screws provided,
mount blower and tighten screws se-
curely (see Figure 17).
4. Attach thermal switch and bracket to
inside rear cover wall with two hex
head screws provided as shown in Fig-
ure 17. After securing bracket to rear
cover, carefully bend along existing
bend line on bracket to almost a 90
°
angle (see Figure 17). This will allow
thermal switch to be positioned against
stove rear wall and sense temperature
when in operating mode.
Figure 17 - Blower Assembly, Speed
Control, and Thermal Switch Locations
Figure 16 - Removing Rear Cover and Bottom Cover from Stove Body
Speed
Control
Blower
Control
Knob
Locknut
Blower
Assembly
Thermal
Switch
and
Bracket
Control
Shaft
TOP VIEW
Stove Body
Rear Cover
Bottom Cover
Hex
Screws
Mounting
Screws
Mounting
Screws
Hex Screws
Mounting
Screws
Mounting Holes
Mounting
Holes
Right Top
Grate
Center Top Grate
(Included with Stove Body)
Left Top
Grate
Continued
Screws