VTech IP811 - Manual (Page 6)

Getting Star
ted
Installation of Battery Pack
1. Remove battery compartment cover by
pressing on the indentation and sliding
downward.
2. Place the new battery pack in the handset
with the positive and negative poles aligned
in the battery compartment.
3. Replace the battery pack cover by sliding
it upwards.
4. If the new battery is not already charged,
place the handset in its charger and allow
it to charge for 10-12 hours.
5. After the initial charge, a maintenance
charge of 10-12 hours should be suffi-
cient. Be sure to place the handset in
its charger when not in use to insure maxi-
mum daily performance.
6. Average talk time on a fully charged
battery is about nine hours, standby time
is approximately four days.
Setup
Connecting Power to Handset Charger
Because the IP 811 is an accessory handset to the IP 8100-2/8100-3 all you need to
do is choose the location for your handset charger and plug in the power supply into an
electrical outlet.
CAUTION: Use only the VTech power supply provided with your telephone.
5
811.vcan.om.eng.indd 5 10/27/05 11:16:25 AM