Welch Allyn SCANTEAM 6920 - Manual (Page 13)

8 SCANTEAM 6920 User’s Guide
Dip Switch Feature Selection
Parameter
Lower & Upper
Case Control
Setting
SW 1
Configurations
Always Upper Case
OFF*
Keyboard Control
ON
Keyboard Type Setting
SW 2
AT
OFF*
XT-PS/2 models
25/30/70
ON
SS, ES Code Setting
SW 3
Enabled
OFF*
Disabled
ON
Carriage Return
Setting
Setting
SW 4
CR None
ON
After Each
Track
ON*
Keystroke Speed
Characters per second
Setting
SW 6
80 C/S
OFF*
25 C/S
ON
Output Type
(Factory Set)
Setting
SW 7
Reserved
OFF*
Mode Setting
SW 8
Normal Operating
ON*
Keyboard Programming
OFF
SW 5
After All
Tracks
OFF
Reserved
OFF
ON OFF* ON OFF
➅
➂ ➃
➄
➄
➁
Notes:
➀
Asterisk (*) Indicates Factory Default Setting.
➁
Use this configuration if your PS/2 uses AT type keyboard scan
codes.
➂ When using XT Mode, SW 1 must be set ON.
➃
This DIP switch setting value can be changed in Keyboard
Programming Mode. See “Using Keyboard Programming
Mode to Set Keyboard Type,” page 10.
➄
This DIP switch setting value can be changed in Keyboard
Programming Mode. See “Using Keyboard Programming
Mode to Set Keystroke Speed,” page 9.
➅ See page 9 for information about using the “Keyboard
Programming” Mode switch (SW8).