Welch Allyn SCANTEAM 6920 - Manual (Page 9)

4 SCANTEAM 6920 User’s Guide
Installation
All SCANTEAM 6920 MSRs are shipped with the configuration
set to AT type keyboard scan codes, and set to allow the MSR to
autoĆdetect the state of the Caps Lock" key on the host PC.
The SCANTEAM 6920 draws all power from its keyboard
interface cables, and thus does not require an external power
pack.
The SCANTEAM 6920 is easily installed into a PC system in the
following steps:
1) Turn the system power off.
2) Unplug the PC keyboard's connector from PC's rear panel
connector port.
3) Plug the keyboard's connector into one of the MSR's pigtail
connectors.
4) Connect the other MSR pigtail connector into the keyboard
port on the PC's rear panel
5) Turn the system power on.
6) Test the SCANTEAM 6920's host interface configuration by
passing a magneticstripe card through the SCANTEAM
6920. The magneticstripe data should appear on your PC
screen as if you had typed it into the PC. If the data does
not appear on the screen, you may have to modify the
output data configuration of the SCANTEAM 6920 (see
page 6, Configuration Options).
Caution: Always turn power to the host PC off before connecting,
disconnecting, and/or changing DIP switch settings.