Wegener Communications 6400 - Manual (Page 3)

iP UMP 6400 Q UICK S TART G UIDE iP UMP 6400 Q UICK S TART G UIDE
800009-03 Rev. A 10 Professional Video Professional Video 3 800009-03 Rev. A
8 To configure your iPump's decoder output , navigate
from the
Home
screen to the
Decoder Setup
screen as follows:
Step Press Display / Field Details Screen Type
a. ENTER RECORD AND PLAY Menu
b. w w DECODER SETUP Menu
c. ENTER DECODER NUMBER
1
(Available decoders are 1 and 2. If your iPump
has only one decoder, this Decoder Number
screen will not appear. Instead, the Decoder
Setting Select
screen described in step e will
appear.
User Input -
Selectable
d. w w DECODER SETTING SELECT:
FOLLOW TUNE
(FOLLOW TUNE accepts the program selection
from the current RF setup and sends you back
to the Decoder Setup screen. PROGRAM
allows you to select a particular program from
the stream. OFF turns off the decoder)
User Input -
Selectable
If PROGRAM is selected, go on to step f. Otherwise your decoder setup is
complete.
e. ENTER ENTER PROGRAM NUMBER:
001
(Number of program to select from stream.
Available program numbers are dependent on
transport stream.)
User Input -
Selectable
Your decoder setup is now complete. The selected program will
begin playing from the selected decoder.
9 9 For web browser control For web browser control and status checking, first
navigate from the home screen to the
IP Setup
screen as follows:
Welcome to your iPump Media Server/Store and Forward
Receiver !
Your Wegener iPump is an advanced multimedia
appliance that allows simple, efficient management of both live and
recorded digital video, audio, and data content. With a single unit,
you can receive, decode, and play out broadcast-quality
transmissions while receiving and recording multiple programs or IP
data files from a satellite or TCP/IP connection. Along with our
Compel MediaPlan ® software, you can insert content into real-time or
recorded programs and can schedule playback of custom sequences
of live and recorded content. This Quick Start Guide will help you
quickly set up and start operating your iPump. For a full description
of the iPump's abilities and detailed installation and operation
instructions, please consult the iPump User's Reference Manual
available on the worldwide web at wegener.com. For additional help,
contact us by phone at (770) 814-4057, by fax at (678) 624-0294, or
by email at [email protected].
1. Remove your iPump, ac power cord, and bagged
accessories from the shipping carton. Call your shipping carrier
immediately if any damage is discovered.
2. Place your iPump indoors on a well-supported, flat table or
desktop or mount it in a standard equipment rack. If rack-
mounting your iPump, please consult the iPump User's
Reference Manual for detailed instructions and specific cautions.
3. Connect Connect the following items (refer to Figures 1 and 2):
f. The L-band output from your antenna's LNB to the iPump's RF
input port (a) [950 to 2150 MHz; female Type F connector
with extender cable attached or BNC connector if your unit
has the optional ASI input]
g. A suitable monitor to the iPump's audio port ( b). [A DB-15 HD
cable assembly is included.]
h.
A suitable video monitor to the iPump's video port ( c1) [c1 is
a female BNC for SDI.] or ( c2) [c2 is a female BNC for
composite video.]
Note: Repeat steps (b.) and (c.) for the second decoder if your
iPump is equipped with two decoders.