Wegener Communications 6400 User Manual
Page 4
iP
UMP
6400 Q
UICK
S
TART
G
UIDE
iP
UMP
6400 Q
UICK
S
TART
G
UIDE
8000009-03 Rev. A
4
Professional Video
Professional Video
9
800009-03 Rev. A
i.
Y our LAN line to the iPump's Ethernet port (
d
d) [10/100baseT;
female RJ-45 connector]
Figure 1. iPump Rear-Panel Connectors
The Alarm port (
e
e, Figure 1) on the rear panel may be used to
provide a contact closure during alarm conditions or on
command from Compel. See the iPump User’s Manual for
complete connector and signal details.
Figure 2. iPump Connections
Note: Do not connect devices to the mouse, keyboard and other
connectors not described here. They are for factory use only.
LED Label
Color and State
Meaning
GREEN constant
Current transport stream is protected by
conditional access (CA) and iPump is
authorized and descrambling.
GREEN slow blink
Current transport stream is protected by
conditional access (CA) but iPump is
unauthorized.
AUTH
Off
Tracked channel is not scrambled ("in the
clear").
AMBER constant
One or more warning conditions exist. Read
warning information from front-panel LCD.
WARNING*
Off
No warning conditions exist.
RED constant
One or more alarm conditions exist. Read alarm
message from LCD.
ALARM*
Off
No alarm condition exists
*
Only one alarm or warning condition is displayed at a time on the LCD. When
multiple alarm or warning conditions exist, those conditions are displayed in the
order of importance. The most critical condition is displayed first and others may be
viewed by pressing the right arrow button w
w
.
7. Set up or adjust your
Set up or adjust your iPump's RF settings
iPump's RF settings at the front
panel. (If your unit has the optional ASI input, this step is not
necessary - go to step
7
). From the home screen, navigate to the
RF Setup
screen as follows:
Note: Use the arrow buttons to move left and right through the
menu screens and the
ENTER
button to move down a level.
Use the
ESC
button to move upward through the menu
screens. By pressing
ESC
repeatedly, you can always return
to the
iPump
home screen.
Step
Press
Display / Field Details
Screen Type
a.
ENTER
UNIT SETUP
Menu
b.
w
w
UNIT SETUP