White Outdoor Yard Boss 950 - Manual (Page 7)

7
Figure 5
Clutch Cable Adjustment
Adjust the hex nuts at the cable bracket so there is no
slack in the cable, but the cable should not be tight. Do
not overtighten the cable. See Figure 5.
To check the clutch adjustment, proceed as follows:
• Push the chipper shredder vacuum backward and
forward with the drive clutch handle released. It
should move freely.
• If it does not, loosen both hex nuts at the cable
bracket. Turn bottom nut clockwise to loosen the
cable. See Figure 5.
• Engage the drive clutch handle and try to push unit
backward and forward. The wheels should lock up.
• If the wheels do not lock up, loosen both hex nuts at
the cable bracket. Turn bottom nut counterclock-
wise to tighten the cable.
• Recheck adjustment and tighten both hex nuts
when correct adjustment is reached.
Attaching The Bag
• Place bag under of upper handle assembly and slip
the front opening on the bag over the discharge
chute, making certain it is over the rim on the
discharge chute. See Figure 6.
Figure 6
• Place the four straps on the top of the bag over
upper handle, hooking them on the studs to secure
in place. Be sure the bag is under the drive clutch
handle. See Figure 7.
Figure 7
SECTION 3: KNOW YOUR CHIPPER SHREDDER VACUUM
WARNING: Be familiar with all controls
and their proper operation. Know how to
stop the machine and disengage them
quickly.
Bag
Collects shredded or chipped material fed through the
chipper chute or vacuumed up through the nozzle.
See Figure 8.
Chipper Chute
Allow twigs and small branches up to 3” in diameter to
be fed into the impeller for chipping. See Figure 8.
Nozzle Height Adjustment Knob
Used to adjust the nozzle ground clearance that will
provide the best performance for the operating
conditions. See Figure 8.
Nozzle
Yard waste such as leaves and pine needles can be
vacuumed up through the nozzle for shredding. See
Figure 8.
Drive Clutch Handle
The drive clutch handle is located above the upper
handle assembly. Squeezing the drive clutch handle
against the upper handle engages the wheel drive.
Release the drive clutch handle to stop the wheel drive.
See Figure 8.
Hex Z End
Nuts
Drive Clutch
Handle
Discharge
Chute Bag Bag Opening
Upper Handle
Bag Straps
Bag Straps Bag