White Outdoor Yard Boss 950 - Manual (Page 8)

8
Shift Lever
The shift lever is located on the top right hand side of
unit. It is used to adjust the ground speed of the chipper
shredder vacuum when the drive clutch handle is
engaged. The shift lever can be place in one of eight
positions: six forward and two reverse positions.
See Figure 8.
Starter Handle (Not Shown)
The starter handle is located on the engine. Pull the
starter handle to start engine.
Engine Controls
See the separate engine manual for the location and
function of the controls on the engine.
Throttle Control Lever (Not Shown)
The throttle control lever is located on the engine. It
controls the engine’s speed and stops the engine. See
separate engine manual packed with unit for details.
Stopping Engine
• Move throttle control lever to STOP or OFF
position.
• Disconnect spark plug wire from spark plug and
ground against the engine.
Figure 8
SECTION 4: OPERATING YOUR CHIPPER SHREDDER VACUUM
WARNING: Read, understand, and follow
all instructions and warnings on the
machine and in this manual before
operating.
WARNING: Always wear the safety
glasses provided with this machine during
operation or while performing any adjust-
ments or repairs. Thrown objects which
ricochet can cause serious injury to the
eyes.
Gas And Oil Fill-Up
Service the engine with gasoline and oil as instructed in
the separate engine manual packed with your chipper
shredder vacuum. Read instructions carefully.
WARNING: Use extreme care when
handling gasoline. Gasoline is extremely
flammable and the vapors are explosive.
Never fuel machine indoors or while the
engine is hot or running. Extinguish
cigarettes, cigars, pipes, and other
sources of ignition.
Starting Engine
• Attach spark plug wire to spark plug. Make certain
the metal cap on the end of the spark plug is
fastened securely over the metal tip on the spark
plug.
• Make certain drive clutch handle is in the
disengaged (released) position.
Bag
Chipper
Chute
Nozzle Height
Adjustment Knob Nozzle
Drive Clutch
Handle
Shift Lever