Waves Parametric Convolution Reverb IR-360 - Manual (Page 5)

Controls and Displays
C
ONTROLS
T
IME
: 0.10 – 20.00sec. Default: 2.00
Reverb time in seconds, defines how many seconds it will take any sound to
decay by 60dB (RT
60
).
W
ET
/D
RY
: 0=Dry,100=Wet. Default:100.
This controls the balance between the Dry input signal and the generated Reverb
signal. In Send scenarios it is common to use the fully wet output.
Reverb Damping Controls
The Reverb Damping controls define longer or shorter decay for the Hi or Low
Frequencies in relation to the main Reverb Time.
L
OW
D
AMP
F
REQ
: 16 – 1600Hz. Default:160Hz
Defines the frequency below which the Reverb time is controlled by the Low
Damping Ratio Control .
L
OW
D
AMPING
R
ATIO
: 0.10 – 2.00. Default :1.10
Defines the ratio by which the frequencies below the Low Damp Frequency will
decay in relation to the general Reverb Time. Values less than 1.00 are shorter,
and values greater than 1.00 are longer than the general Reverb Time.
H
I D AMP F REQ : 1000 – 21000Hz. Default: 2625Hz
Defines the frequency above which the Reverb time is controlled by the Hi
Damping Ration Control.
H
I D AMPING R ATIO : 0.10 – 2.00. Default: 1.10
Defines the ratio by which the frequencies above the Hi Damp Frequency will
decay in relation to the general Reverb Time. Values less than 1.00 are shorter,
and values greater than 1.00 are longer than the general Reverb Time.
Waves R360 software guide page 5 of 8