Yamaha DVD-C961 - Manual (Page 36)

32
En
Setup Menu
Setting the digital output
You can set the digital output and LPCM
output.
• Select [DIGITAL AUDIO] in “AUDIO
SETUP PAGE”.
DIGITAL OUTPUT
Set the digital output according to your
optional audio component connections.
OFF
Select this to turn off the digital output.
ALL
Select this if you have connected the digital
audio output jack to a multi-channel decoder/
receiver.
Dolby Digital, DTS, MPEG-2 and PCM digital
audio signals are output.
Also refer to the manual supplied with the
connected component.
PCM ONLY
Select this only if your receiver is not capable
of decoding multi-channel audio signals.
Multi-channel audio signals are converted to
2-channel linear PCM audio signals.
LPCM OUT
Select this if you have connected this unit to a
PCM-compatible receiver via a digital jack,
such as a coaxial jack. In this case, you may
need to adjust [LPCM OUT].
Discs are recorded at a certain sampling rate.
The higher the sampling rate, the better the
sound quality.
48KHz
Select this to play back discs recorded at the
sampling rate of 48 kHz. All higher than 48
kHz PCM data streams (if available) are
converted to the sampling rate of 48 kHz or
lower.
96KHz
Select this to play back discs recorded at the
sampling rate of 96 kHz. If higher than 48 kHz
disc is copy protected, the digital output is
automatically converted to the sampling rate of
48 kHz or lower.
• When HDMI audio signals are output, you cannot
select [DIGITAL AUDIO].
• When Dolby Pro Logic II decoder is activated,
the sampling rate of digital output is limited to 48
kHz or lower.
Setting the HDMI audio output
When you connect this unit to an HDMI
compatible component via the HDMI jack, set
the HDMI audio output to match the
connected component. For details about the
relationship between the audio format and the
setting, see “HDMI audio output” on page 13.
• Select [HDMI AUDIO OUT] in “AUDIO
SETUP PAGE”.
AUTO
Select this to set this unit to the best setting
automatically based on the component you
have connected via the HDMI jack.
PCM
Select this to output the decoded multi-
channel or 2-channel PCM audio signals via
the HDMI jack. To select multi-channel or 2-
channel output, set [ANALOG OUTPUT] (see
page 31).
OFF
Select this to turn off the HDMI audio output.
• If the monitor/receiver connected to this unit
using HDMI does not support HDMI audio signal
input, set this setting to [OFF].
• When [HDMI AUDIO OUT] is set to [AUTO] or
[PCM], digital output signals are muted.
Turning the speaker setup on/off
This function is used to enable or disable the
speaker settings.
• Select [SPEAKER SETUP] in “AUDIO
SETUP PAGE”.
ON
Select this to enable to set [SPEAKERS] (see
pages 33).
Notes
Notes