Well Traveled Living 60790 - Manual (Page 14)

- 14 -
CAUTION: Avoid inhaling fumes emitted from the heater’s first use.
Smoke and odor from the burning of oils used in manufacturing will
appear. Both smoke and odor will dissipate after approximately 30
minutes. The heater should not produce thick black smoke.
Note:
The burner maybe be noisy when initially turned on. To
eliminate excessive noise from the burner, turn the control
knob to the “LOW” position, then turn the knob to the level
of heat desired.
Warning : White smoke may appear around the radiant
head during the first minutes of the initial firing.
When heater is ON:
Emitter screen will become bright red due to intense heat. The
color is more visible at night. Burner will display tongues of blue
flame. These flames should not be yellow or produce thick black
smoke, indicating an obstruction of airflow through the burners.
If the flame is very small, this indicates the supply pressure is not enough.
Relighting the heater:
1) Turn the control knob to “OFF” position.
2) Wait five (5) minutes before attempting to relight pilot.
3) Repeat steps beginning with step 2 on page 12.
Before leaving the heater unattended:
1) Turn the control knob to “OFF” position and turn LPG
cylinder to “OFF” position.
2) Never leave the patio heater unattended while in use.
Shut down instructions:
1) Push in and turn control knob clockwise to “OFF” position.
2) Turn LPG cylinder valve clockwise to “OFF” position when heater is not in use.
NOTE: After use, some discoloration of the emitter screen is normal.
If you suspect gas leakage:
1) Turn the control knob to “OFF” position.
2) Turn LPG cylinder valve to “OFF” position.
3) Wait 5 minutes to allow gas to dissipate.
4) If odor continues, immediately call gas supplier. DO NOT use the heater.
Warning: Heater will be hot after use. Handle with extreme care until completely
cooled.
OPERATION