Winegard RC-DT09 - Manual (Page 4)

- 4 -
Battery Replacement
When the batteries become weak, the operating distance of the remote control is greatly reduced
and you will need to replace them.
To Install Batteries
2. Insert two AAA batteries.
• Point the remote control at the REMOTE SENSOR located on the unit.
• When there is a strong ambient light source, the perform ance of the infrared REMOTE SENSOR
may be degraded, causing unreliable operation.
• The recommended effective distance for remote operation is about 16 feet (5 meters).
1. Open the battery door.
REMOTE CONTROL
Notes:
• If the remote control is not going to be used for a long time, remove the batteries to avoid corrosion
damage caused by battery leakage.
• Do not mix old and new batteries. Do not mix ALKALINE, standard (CARBON-ZINC) or rechargeable
(NICKEL-CADMIUM) batteries.
• Always remove batteries as soon as they become weak.
• Weak batteries can leak and severely damage the remote control.
• WARNING: Do not dispose of batteries in a fi re. Batteries may explode or leak.
CAUTION: Danger of explosion if battery is incorrectly replaced. Replace only with the same
or equivalent type.
IB_English.indd 4 IB_English.indd 4 2/19/2008 5:06:22 PM 2/19/2008 5:06:22 PM